segment descriptor造句
例句与造句
- This default ldt segment descriptor is stored in the gdt
这个默认ldt段描述符存储在gdt中。 - By default it contains a null segment descriptor
默认情况下，其中会包含一个空的段描述符。 - The corresponding segment descriptor stored in the gdt has following values
存储在gdt中的对应段描述符的值如下： - Each segment descriptor is eight bytes long and represents a single segment in memory
每个段描述符长8个字节，表示内存中的一个段。 - A 13 - bit index that identifies the corresponding segment descriptor entry contained in the gdt or ldt
一个13位的索引，用来标识gdt或ldt中包含的对应段描述符条目 - It's difficult to find segment descriptor in a sentence. 用segment descriptor造句挺难的
- Each time a segment selector is loaded on to segment registers , the corresponding segment descriptor is loaded from memory into a matching non - programmable cpu register
每次将段选择器加载到段寄存器中时，对应的段描述符都会从内存加载到相匹配的不可编程cpu寄存器中。 - Since a segment descriptor is eight bytes long , its relative address inside the gdt or ldt is obtained by multiplying the most significant 13 bits of segment selector by 8
由于一个段描述符的大小是8个字节，因此它在gdt或ldt中的相对地址可以这样计算：段选择器的高13位乘以8 。 - For example , if the gdt is stored at address 0x00020000 and index specified by segment selector is 2 , then the address of corresponding segment descriptor is equal to 0x00020000
例如，如果gdt存储在地址0x00020000处，而段选择器的index域是2 ，那么对应的段描述符的地址就等于( 2 * 8 ) + 0x00020000 。 - The ti table indicator flag that specifies whether the segment descriptor is included in gdt if the value is 0 ; if the value is 1 , then the segment descriptor is included in the ldt
Ti ( table indicator )标志指定段描述符是在gdt中还是在ldt中，如果该值是0 ，段描述符就在gdt中；如果该值是1 ，段描述符就在ldt中。 - The segment descriptor entry contains both a pointer to the first byte in the associated segment represented by the base field and a 20 - bit value the limit field which represents the size of the segment in memory
段描述符条目中包含一个指针和一个20位的值（ limit字段） ，前者指向由base字段表示的相关段中的第一个字节，后者表示内存中段的大小。 - As we saw earlier in the section on linux and segmentation , each segment descriptor uses same set of addresses for linear addressing , minimizing the need to use the segmentation unit to convert logical addresses to linear addresses
前面介绍linux分段模型时已提到，每个分段描述符都使用相同的地址集进行线性寻址，从而尽可能降低使用分段单元将逻辑地址转换成线性地址的需要。